Years of mold industry experience
Guangzhou injection mold manufacturer
Consulting Hotline: 020-82167229 13925109060
Many people do not know the relevant terminology of mold processing, the following will be explained to you by the Guangzhou injection molding factory
1. Here is a clear two-dimensional corner of the dead corner. The part that has not arrived in the previous process, such as where the light knife should go first, and then the knife, which is too small, the deep corner can be divided into several knives. Do not use a knife to clear too. Many places.
2, clear stereo angle: open several small slots, some solid angle.
3. It is easy to break the knife, such as a fine knife, which is too long and the processing amount is too large (mainly z, depth direction).
4, knife path: walking has a two-dimensional shape, only a clear small angle (R0.8) and the angle of the two-dimensional plane; with a parallel path; with the contour; the surface and shape of the knife that has a place to go must not go dead end must Seal the knife first, and then clear the corners. The small gaps facing each other are usually closed first.
1. In the light: As the surface of steel and beautiful public talents in the light.
2. Principle: When thickened, there is more room for layer by layer. In order to make the knife work better in one process,
3, Features: Quick removal, large knife and fast knife are also available, large feed, large distance; don't worry about surface quality; flat workpiece without light; keep the outline shape of the workpiece without adding light, put the two processes together and become thinner The distance between the edge layer and the layer of the surface; without light, there is another important factor is the work of the material, the harder the material, and the light is considered; the direction of the light processing and the light knife are relatively rough, it is best to process such things Cause uh, even.
Optical knives are required to achieve the assembly of various products and molds, so be very careful, and give different tool path settings and parameter settings according to different requirements.
1. The height of the knife and the final height of the knife are both changed to 0. The tolerance in the wire in the design is not filtered (the smaller the workpiece, the tolerance affects the appearance).
2. The front mold and the parting surface achieve the best finish. After the mold can be doubled, other uncooperative and avoidance can be rough parts.
For more information, please follow http://hotel-azura.com/